AUTONET TV

Wired! (Battery Cable Service)

Colder weather brings out the worst in a vehicle's battery.  On a very cold day, you may have experienced that your engine cranks slowly when starting.  But while it may be the battery itself, it may also be the parts that transfer the power to other the other electrical components, the battery cables.  After all, you have to have some way to get the current out of the battery and out to where it needs to go.

Battery cables have a couple of enemies: corrosion and age.  You may have looked under the hood and noticed a light-colored powder or crust around the terminals.  That's what happens when acids corrode the ends of the battery terminals.  Corrosion inhibits the connection and may reduce the amount of power getting to the electrical accessories to the point where they are not working correctly, if at all.

Here are some symptoms of problems with your battery cables. You might notice a clicking sound when you turn the key, some of your vehicle's electrical parts (like the sound system or the horn) don't work or, in some cases, the vehicle won't start at all.

When you take your vehicle to a repair facility, the technician will use instruments to check voltages to see how much current is getting to what location. That includes a starter draw test during which the battery's voltage is checked when the starter is cranked.  The technician will also visually inspect the cables and the charging system. To make sure the alternator is putting out the right voltage, the technician will measure that as well. 

If the problem is found to be the battery cable assembly, the entire set may have to be replaced. Sometimes they can be repaired. 

During the colder months, it's vital that your vehicle has the proper power going to its electrical components.  Having a vehicle that won't start or run smoothly is not something you want to battle with when you're already up against challenging weather.  Keep your electrons flowing… and your vehicle moving.

Bauer Auto Service
14455 State Hwy 23
Cold Spring, MN 56320
320-685-8846

What's in a Number? (What Tire Numbers Mean)

You've probably never paid much attention to the writing on the sides of your tires, but they contain a wealth of information.  There's a long combination of letters and numbers that can tell you a whole lot about what tires your vehicle was designed to be riding on.  Let's check out this example found on an SUV: P245/70R17 108T.

The first letter, P, means it's intended for passenger vehicles.  If there's no letter, it means it's a metric tire.  If there's an LT at the beginning or end that means a tire designed for light trucks.

Moving on to our example, the 245 shows how wide the tire is in millimeters from sidewall to sidewall.  The number that follows in our example, 70, means the height of the tire is 70% of its width.  The letter after that in our example, R, describes the type of tire (on this vehicle, radial).  Following that is the diameter in inches, in our SUV example, 17 inches. 

How much load the tires' sidewalls are designed to take is what that next number is all about (108 in our example).  The higher the load index, the more weight the sidewalls can take.  And the last letter is the speed rating of the tire, in our example, T.  The further along in the alphabet that letter is, the higher its speed rating.  So now you know what those letters and numbers mean.  But why are they important?

When you are getting ready to replace those tires, those numbers are telling you what the original equipment was when your vehicle was new.  Sticking with the same rated tires is always a good idea.  If you don't know what you're doing, trying different sized tires and wheels can cause real issues when it comes to performance and safety, considering all the computerized systems now found on vehicles.  When in doubt, consult your service advisor when it comes to buying new tires.  He or she knows what those tire numbers and letters mean… and a whole lot more.

Bauer Auto Service
14455 State Hwy 23
Cold Spring, MN 56320
320-685-8846

What Is an EGR Valve? (EGR Valve Service)

If you've ever felt your vehicle hesitate, go, then hesitate again, you might think there's something wrong with the transmission.  After all, it's not moving smoothly  down the road.  But there are plenty of malfunctions that can cause those symptoms, one of them being something you may have never heard of: the EGR valve.

EGR stands for Exhaust Gas Recirculation. It's a system that channels small amounts of exhaust back into the engine to cool down the cylinders and reduce polluting gases.  Those include nitrogen oxides that can cause smog. The EGR valve regulates how much of the vehicle's exhaust gas is recirculated. After years and long distances traveled, that valve can get clogged or fail. Sometimes the EGR valve can stick open.  When the EGR valve isn't working properly, your vehicle can start releasing those nitrogen oxides and pollute the air.

The symptoms of a malfunctioning EGR valve include:

• Engine losing power
• Engine idling roughly
• Pinging and knocking sounds in the engine
• Stalling and hesitation
• Fuel economy decreasing
• Check Engine light illuminated

Depending on its condition, the EGR valve can be cleaned or it may need to be replaced.  Consult with your service advisor to see what options are recommended to you.

The EGR system is part of your vehicle's pollution and emissions control equipment. If you care about keeping our planet's atmosphere clean, you'll want to make sure it's doing its job—for everyone's benefit.

Bauer Auto Service
14455 State Hwy 23
Cold Spring, MN 56320
320-685-8846

The Flat Fix that Fits (Tire Repairs)

Can you think of anyone who likes getting a flat tire?  Of course not.  But when one of your tires winds up with a flat or leak, whether it be from things like hitting a curb, running over a nail or picking up a sharp stone, it's time to have someone who knows what they're doing take care of it.

If you're thinking you'd like to avoid having to buy a new tire, you wonder if a patch or plug will suffice.  It depends where the puncture is and how big the hole is.  Most tire experts will say if the hole in the tire is less than ¼ of an inch or 6 mm, a patch can work.  But a patch likely won't work if the compromised part of the tire is on its shoulder or sidewall.

Here's why.  The shoulder of a tire is the part between the sidewall and tread and it's usually rounded.  It's under a lot of pressure, more than even the sidewalls. And because of that curved shape, it's hard to get a patch or plug to hold.

The sidewall is the side of the tire.  Sidewalls flex a lot when you drive, and the strain can cause a patch or plug to loosen up.  A weak spot in a sidewall is much more likely to fail and cause a blowout.  So if you have damage in the sidewall or shoulder, that tire is a good candidate for replacement, not repair.

If you have a cut or gash in your tire, it's possible the cords that strengthen your tire have also been cut.  That weak spot can spell trouble, and this type of damage usually means you should get a new one.

Your service advisor can tell you what the appropriate action is to take when you have tire damage.  You may be able to get good results with a patch, or you may have to replace one or more tires.  Your safety is riding on them.

Bauer Auto Service
14455 State Hwy 23
Cold Spring, MN 56320
320-685-8846

Not Too Hot and Not Too Cold (Temperature Gauge)

You know your body temperature is supposed to be 98.6 degrees F, 37 degrees C.  Your vehicle has a normal temperature, too, and if you pay attention to it, that can save you some big headaches down the road.

Many vehicles have a temperature gauge on the dash that takes the temperature of the engine's coolant.  Some have a thermometer symbol, some read C-H (cold to hot). Many will have a red zone that shows when water temperature is getting into the danger zone.  Others are digital and have a red warning light that signals overheating.  And some vehicles have a light that goes on when the engine temperature is out of the normal range.

If your vehicle has a gauge, pay attention to it.  If you need help locating it, ask one of our Bauer Auto Service experts to give you a quick explanation.  Chances are when the vehicle has been running for 15 minutes or more, the temperature gauge will settle into its own "normal" zone, often just below the midway point.  If you have a digital readout, remember what that "normal" temperature is.  Here's why.

At any point when you're driving, the temperature gauge is the quickest way to get a sense that the engine is running the way it should, a quick health checkup, as it were. Say you're on a 3-hour trip, glance at that gauge every hour or so.  It should always be in the same spot.  If it starts to move one way or the other, you may be able to catch a problem before it gets serious.

Pay special attention to it moving into the hot zone.  The needle on the gauge is the easiest and least distracting way to see an engine heating up, but on a digital gauge, start paying attention if the temperature reaches 240ºF/115ºC or more.

Remember, though, that just because the gauge reads "hot" doesn't mean your engine is on the verge of burning up.  It could be a bad sensor and the engine will be at a normal temperature.  But it also could be a failing water pump, coolant leak or thermostat.  By pulling off the road and observing your engine, it will give you a pretty good idea if it's running hot or not.

If the gauge is too "cold," it could be a broken gauge or thermostat sticking open.  Usually being in the cold range isn't as worrisome, but you should have it checked out since other systems may be affected.

Heat is one of a vehicle's worst enemies, especially when it comes from within.  Know your vehicle's normal temperature and keep an eye on it.

Bauer Auto Service
14455 State Hwy 23
Cold Spring, MN 56320
320-685-8846

How to Radiate Cool (Radiator Care)

There's nothing that radiates cool like a vehicle radiator that's helping to keep your engine running at the proper temperature.  You don't have to baby it, but you can't simply ignore it, either. 

Let's take a quick dive under the hood to let you know what the radiator is doing.  It takes the heat your engine produces and moves that heat outside.  It's not an easy job and heat is an engine's number one enemy.  Now that you're thinking how nice you want to be to your radiator, we have a couple of ideas how you can take care of it.

The easiest thing is to pay attention to your vehicle's temperature gauge. If it gets in the "too hot" or "not hot enough" range, have it checked out soon.  Make sure your coolant is kept at the correct level and if you see a trend that you have to add coolant more than a couple of times a year, you might have a leak.

Even if there are no obvious problems, every couple of years or so, consider taking your vehicle in for radiator maintenance.  A technician can run a pressure check for leaks and ensure that the thermostat and radiator cap are working correctly.  The technician will check that fans are running like they should so they can move air over the radiator and heat away from the coolant inside.

Ask your service advisor when you should have your radiator flushed and coolant replaced according to the manufacturer's recommended intervals.  In addition to cooling, coolant has corrosion inhibitors which stop working after a while.  Without those corrosion inhibitors, the inside of your radiator can literally start rotting away.  Keep in mind that the coolant level must be kept at manufacturer's specifications since if those corrosion-preventing chemicals aren't touching the metal, they're not preventing corrosion. 

Different vehicles use different coolants, so your service facility will make sure yours is getting the correct one.  Keep your coolant system happy and one day, maybe you can order up a custom license plate, "RAY-D-8."

Bauer Auto Service
14455 State Hwy 23
Cold Spring, MN 56320
320-685-8846